STMicroelectronics Dual Radio BLE and Sub-1GHz Development Kit WS2118-00 Bluetooth Development Board for Arduino,

The STEVAL-FKI001V1 development kit is a cost-effective tool to help you design solutions based on Sigfox™, Bluetooth® low energy and sub-1GHz technologies. The kit features a fully programmable module WS2118 (by Jordin), which embeds theBlueNRG-1 system-on-chip for Bluetooth® low energy functionality and the S2-LPtransceiver for sub-1GHz functionality such as LPWAN protocols. This development effectively combines Bluetooth low energy features with the connection capacity of Sigfox wide-area networks. It includes examples and recommendations regarding the simultaneous use of the two protocols. Very low active RF and MCU current, and low-power mode current consumption provide excellent battery lifetime, allowing operation with coin cell batteries and energy-harvesting applications.Embedded BlueNRG-132 Bluetooth low energy SOC based on ultra-low power Arm® Cortex®-M0 (up to +8 dBm BLE RF output power, excellent receiver sensitivity -88 dBm) – Embedded S2-LPQTR ultra-low power sub-1 GHz transceiver tuned for 826-958 MHz frequency bands (up to +16 dBm sub-1GHz RF output power, excellent receiver sensitivity down to -130 dBm, modulation schemes: 2-(G)FSK, 4-(G)FSK, OOK, and ASK, air data rate from 0.1 to 500 kbps, ultra-low power consumption: (7 mA RX, 10 mA TX @ +10 dBm ), low duty cycle RX/TX operation mode, automatic acknowledgement, retransmission, and timeout protocol engine) – BALF-NRG-01D3 50 O integrated balun, matching network and harmonics filter companion device of BlueNRG-1 – Low power and wide supply voltage range: 2.0 to 3.6 V – Dimensions: 22 mm(l) x 24 mm(w) x 2.8 mm(h) – Operating temperature range: -40 °C to +85 °C – U.FL RF interface connectors