Digilent 410-299 for use with JTAG-HS3, Xilinx Tool

USB cable. This cable is not needed for Digilent Xilinx FPGA boards as they have this functionality built-in. JTAG-HS3 FPGA Programming Cable. The JTAG-HS3 programming cable allows high-speed programming/debugging of Xilinx FPGA and SoC devices from a host PC. Features. Separate Vref drives JTAG signal voltages Vref can be any voltage between +1.8V and +5V USB 2.0 HS port drives JTAG bus at up to 30Mbit/sec Compatible with Xilinx ISE 14.1 and newer Compatible with Xilinx Vivado 2013.3 and newer PC connector: MicroUSB JTAG connector: 2 x 7-pin 2mm Open-drain buffer on pin 14 allows processor reset of Xilinx Zynq platform. Supported Target Devices. Xilinx FPGAs. Xilinx Zynq-7000. Xilinx CoolRunner™/CoolRunner-II CPLDs. Xilinx Platform Flash ISP configuration PROMs. Selected third-party SPI PROMs. Selected third-party BPI PROMs. Target Devices Not Supported. Xilinx 9500/9500XL CPLDs. Xilinx 1700 and 18V00 ISP configuration PROMs. Xilinx FPGA eFUSE programming