SEGGER Flasher ARM Programmer

Ethernet cable, 20-pin target ribbon cable, RS-232 serial cable, USB cable. Flasher ARM Programmer. The Flasher ARM is a programming tool for microcontrollers with on-chip or external Flash memory and an ARM core. Flasher ARM is designed for programming Flash targets with the J-Flash software or stand-alone. In addition, Flasher ARM has all of the J-Link functionality. Supported Processors. • ARM Cortex-A: A5/A7/A8/A9/A12/A15/A17 • ARM Cortex-M: M0/M0+/M1/M3/M4/M7 • ARM Legacy: ARM7, ARM9, ARM11. Features. • Stand-alone JTAG/SWD programmer (Once set up, Flasher can be controlled without the use of PC program) • 10/100 Ethernet via RJ45 connector • Supports internal and external Flash memory devices • 64MB memory for storage of target program • Serial in target programming supported • Data files can be updated as mass storage or via J-Flash • Host interface: USB 2.0 or RS-232 DE9 connector • Target interface: JTAG/SWD 20-pin • Powered through USB connection • Can be used as J-Link (JTAG emulator) with download speed up to 1MB/sec • Programming speed typically between 30KB/sec and 1MB/sec • Max programming speed depends on target hardware and max programming speed of the Flash memory • ASCII command interface to control Flasher without use of PC program • Authorized Flashing allows limit to number of Flash programming cycles and to protect the Flasher against non-authorized access in case of external production • Dimensions: 121 x 66 x 30mm • Free software updates, 2 years of support