A thread limit plug gauge is a combination of go plug gauge and no-go plug gauge. The scrap side of the thread plug gauge is marked with a red ring. The go end of the thread plug gauge must screw i...
Volkel Go No-Go Plug GaugeThe Volkel Go No-Go plug gauge M6x1 is a combination of GO and NO-GO plug gauge. The scrap side of this thread plug gauge is marked with a red ring. It is calibrated at a ...
Volkel No-Go Ring GaugeThe Volkel No-Go ring gauge M6x1 is calibrated at a measurement laboratory using IAC thread scanners. These NO-GO thread gauges are marked in red. This thread No-Go ring gaug...
Volkel Go No-Go Plug GaugeThe Volkel Go No-Go plug gauge M8x1.25 is a combination of GO and NO-GO plug gauge. The scrap side of this thread plug gauge is marked with a red ring. It is calibrated at...
The thread NO-GO ring gauge must not screw into the part by hand more than two threads (without using excessive force). If the ring gauge can be screwed into the thread by more than two threads, th...
The GO thread ring gauge must be possible to manually screw into the entire thread of the part (without using excessive force). If unable to do so, the thread does not meet the requested standards ...
A thread limit plug gauge is a combination of go plug gauge and no-go plug gauge. The scrap side of the thread plug gauge is marked with a red ring. The go end of the thread plug gauge must screw i...
The GO thread ring gauge must be possible to manually screw into the entire thread of the part (without using excessive force). If unable to do so, the thread does not meet the requested standards ...
Volkel No-Go Ring GaugeThe Volkel No-Go ring gauge M8x1.25 is calibrated at measurement laboratory using the IAC thread scanners. This No-Go thread gauge is marked in red. This thread No-Go ring ga...
Volkel Go Ring GaugeThe Volkel No-Go ring gauge M8x1.25 is calibrated at a measurement laboratory using IAC thread scanners. This No-Go thread gauge is marked in red. It must not screw into the par...
The thread NO-GO ring gauge must not screw into the part by hand more than two threads (without using excessive force). If the ring gauge can be screwed into the thread by more than two threads, th...