Development Tool Accessories (26 artikelen)

J-Link 19-Pin Cortex-M Adapter. The J-Link 19-pin Cortex-M Adapter allows JTAG, SWD and SWO connections between J-Link and ARM Cortex-M based target hardware systems. Supported Probes. • J-Link BAS...

J-Link RX Adapter. The J-Link RX Adapter maps from the J-Link 20-pin 0.1in connector to the 14-pin 0.1in Renesas connector and allows JTAG + FINE connections to Renesas RX family microcontroller de...

J-Link 9-Pin Cortex-M Adapter. The J-Link 9-pin Cortex-M Adapter allows JTAG, SWD and SWO connections between J-Link and ARM Cortex-M based target hardware systems. Supported Probes. • J-Link BASE ...

The SEGGER J-Link 14-Pin TI Adapter converts the 20-pin, 0.1 inch standard connector to a 14-pin, 0.1 inch Texas Instruments connector.Includes a 14-pin TI cable

J-Link 10-Pin Needle Adapter. The J-Link 10-pin Needle Adapter has been designed to connect a J-Link Probe to a PCB which does not have a mating connector or programming header. Compatible Probes. ...

The SEGGER J-Link TI-CTI-20 Adapter has been designed to connect from the standard J-Link/J-Trace/Flasher 20-pin 0.1″ target connector to TI CTI-20 connector.Adapter permits the connection of the J...

The SEGGER Adapter for PPC targets with 14-pin 0.1″ mating JTAG connectors.Includes a 14-pin ribbon cable

The SEGGER J-Link Mictor 38 Adapter connects the standard 20-pin 0.1″ J-Link interface to the 38-pin Mictor interface. The pinout follows the single target connector pinout specification as defined...

The SEGGER J-Link RX FINE Adapter converts the 20-pin, 0.1 inch standard connector to a 14-pin, 0.1 inch RX FINE connector. Includes the necessary cable.Package includes: .1″ 14-pin ribbon cable (1...

The SEGGER J-Link 2mm Adapter converts the 20-pin, 0.1 inch pitch standard J-Link connector to a 20-pin, 2mm pitch connector.The J-Link 2mm Adapter is a 1:1 adapter

The SEGGER J-Link Signal Smoothing Adapter can be inserted between the J-Link debug probe and the debug target to overcome signal integrity issues. Depending on target load capacitance, signals mig...

The SEGGER J-Link Measurement+Patch Adapter provides test points for all debug signals to allow easy access for test probes. It has a standard 20-pin 0.1″ socket towards the J-Link debug probe and ...

The SEGGER Intel FPGA Adapter (formerly J-Link Altera Adapter) connects to the 10-pin 100-mil Intel FPGA JTAG connector providing debug access to FPGA based MCU cores like the dual-core ARM Cortex-...

The SEGGER J-Link 6-pin Needle Adapter has been designed to connect J-Link to a PCB which does not come with a mating connector or programming header.No additional connector required on your PCB Ve...

The SEGGER J-Link SiLabs C2 Adapter converts the 20-pin, 0.1 inch pitch standard J-Link connector to a 10-pin, 0.1 inch pitch SiLabs C2 connector.Includes 10 pin ribbon cable